Position: Index >

Laser Diode Driver (ICS91718CM)

2017-07-18 19:44  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article describes the Laser Diode Driver (ICS91718CM). The content is very simple, very helpful. Components in this article can help you understand better understanding of this article. For example, in this article, you can go to find and buy these components:ICS91718CM.

We can use a voltage-controlled current source to implement a laser diode driver. Compared with a a Switched (PWM) drivers, this simple? linear laser diode driver provides cleaner drive current. Here is the schematic diagram of the circuit:

laser diode driver circuit schematic diagram

As the basic of this laser diode driver, this circuit uses a Howland current pump with a current booster. The output of a R-R CMOS OPA350 op amp (U2) uses Q1 as the current booster. To sense the current, this circuit uses voltage drop across a shunt resistor (RSHUNT) in series with the laser diode that is? measured differentially. Analog voltage of the microprocessor’s? potentiometer which is controlled by the DAC can be fed to the VIN to control the laser diode current. If we use the values shown in the figure, the scale factor of? output is 1V input equals 1A. Other values of scale factor (VIN/IOUT) can be set by choosing different resistor values using the equation:

VIN/IOUT=RSHUNT(R3/R4), with R1=R3, and R2=R4.

 


Reprinted Url Of This Article:
http://wiringdiagramcircuit.com/laser-diode-driver-2/