Position: Index > Unclassified >

Model Glow Plag driver circuit

2017-08-16 17:42  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

 

Candle core is made of an external  battery , 5 volts or 2 volts. Or one of platinum alloy wire, and a heating coil to start the engine. To complete the battery to start the engine, to provide 12-volt power supply and the second to the third type 6-volt electric fuel pump is often necessary. Model airplanes, boats, cars and the use of a microcosm of the glow plug ignition internal combustion engines (O. Bcc 15CC). These engines are using heavy HT coils, panels, classic condenser spark ignition equipment, while developing a much higher speed (power) of the compression ignition (diesel) engines.

Model Glow Plag driver circuit 
 

Rather than being overwhelmed by these multiple energy sources, the model builder prefer to wear (and buy) a single 12 volt battery, stemming from lower voltages from this by the use of appropriate electronic step-down transformers (choppers). The pilot light and shown it has the additional advantage of (through negative feedback) to maintain a constant temperature independent decision to drown the engine, or age volts while the starter is starting. In this circuit, the PUT relaxation oscillator turns on transistor Ql Q2 output of the chopper at a fixed repetition rate determined by R and C1. The current then flows through the spark plug and the parallel combination of resistor R2 and the current direction indicator associated with the relaxation HILL Schmitt. With the cold cap (low resistance), current is high, the hill is biased `on`, and Q3 results in order to support the base of Q2. Once the cap has reached operating temperature, which can be controlled by its ohmic resistance, theHllL is programmed (via RJ extinguish, remove base drive of Q2 and Q3. However, since the glow plug HAVL sense, no resistance, only val id if the voltage is constant, which is not always the case. Transistor Q4 provides adequate compensation in this case, if the voltage drops (during cold start, for example), the collector current of Q4 rises, causing more current through the diode, thereby delaying the cutoff point for a given socket. The circuit has taken the temperature relatively constant, with the cap is completely dry or completely wet- 'on a range of input voltages from 8 to 16 volts. A similar configuration can be used to maintain a constant temperature of Plug size diesel truck full light (glow plug 28-volt supply, 12 volts), in this case, since the temperature excursions sheet is not so great resistance to expand HR hysteresis may be necessary .. Rc - COMPENSATION VOLTAGE TRIM. Rp - TEMPEflATURE ADJUST PLUG. to -2N6028GENERAL ELECTRIC PCL - Hlll2. Q3 - D29E2 04.05-03301
 

 



Reprinted Url Of This Article:
http://www.next.gr/automotive/automotive-circuits/model-glow-plag-circuit-l11827.html