Position: Index > Unclassified >

More Fun With the Millenium 2 Bypass

2018-01-16 06:17  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

 

More Fun With the Millenium 2 Bypass

Copyright 2000 R.G. Keen. All rights reserved. No permission for local copies or serving from web sites other than http://www.geofex.com.


When I get asked to dream up some effect circuit, usually the problem is how to pick out only one of the ways to do this. This is one of those problems. A reader asked for a way to use the Millenium Bypass but to still have a way to shunt the input of an effect to ground to suppress oscillation or noise from an effect input floating, as it does with the hard-switching arrangement of the Millenium. I came up with three ways to do this, each using a different mix of parts.

The least-fancy one first:

BS170The basic Millenium 2 is shown at left. The leakage from the 1N914 pulls the gate of the BS170 up whenever the control line is opened, so the light is turned on. When that happens, the drain of the BS170 is pulled to ground. Adding a signal diode for isolation and three resistors to drive the base of a bipolar transistor (2N3904) lets this same signal turn the OFF the bipolar transistor when the LED is on. This corresponds to when the effect is engaged.

When the effect is bypassed (LED off) we want the bipolar transistor to turn on. When it's on, the transistor looks like a low resistance to ground, maybe under 50 ohms for garden varieties of transistors, as low as 2 ohms for some specialized ones. The collector is isolated from any DC by the 100uF capacitor and the signal shunt line may be connected to the input of the effect being controlled. When the transistor is on, it shunts the input of the effect to ground through its low collector-to-emitter saturation resistance.

 

Another way to do this is with a JFET or MOSFET as a shunt device.

BS170The illustration at right shows two ways. In the first, similar to the first, the BS170 drain pulls down a signal that controls the shunting element. In this case, it's a 2SK30A JFET. This JFET is biased so that it forms a low impedance to ground through the 0.1uF cap and the 10uF cap in its source bias string.

The last method is essentially the same as the JFET method, but it uses the individual MOSFET transistors in a CD4007 IC to implement both the primary switching of the Millenium, as well as the shunting output.  In invite you to draw out the internals to understand how it's working.