﻿ One Of Nine Sequencer(MTP3055E)_Circuit Diagram World ﻿
Position: Index > Unclassified >

# One Of Nine Sequencer(MTP3055E)

2017-08-04 01:37
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

This article briefly describes the One Of Nine Sequencer (MTP3055E). This principle is easy to understand, but also very practical. Depth understanding of circuit elements, you can better grasp this principle. In this circuit, you can learn about and purchase these components: MTP3055E.

This novel circuit uses a flashingLEDas the clock input for a 4017 decade counter. Typical flashingLEDs (eg,DSEcat Z-4044) flash at about 2Hz so the outputs Q0-Q9 will cycle through at that rate. For example, Q0 will turn on for half a second, then Q1, then Q2 etc up to Q8 then it will start at Q0 again. Up to nine outputs can be used. If you want fewer outputs, connect an earlier output to MR, pin 15. If MR is not used, connect it to 0V.

#### Figure 1 One Of Nine Sequencer Circuit Diagram

Uses for the circuit include sequencing different strings of Christmas lights etc. The resistor from CP0 to ground can be anywhere from about 330O to about 10kO. Lower values will cause theLEDto flash more brightly if that is required. With a 4.7kO resistor as shown, the clock input CP0 (pin 14) will alternate between about 2V and 7V. To drive loads of up to 40W at up to 60V, connect each output to the gate of a 2N3055E or equivalent Mosfet (MTP3055E etc), as shown for Q0.

Reprinted Url Of This Article:
http://www.eeweb.com/blog/extreme_circuits/one-of-nine-sequencer
Maybe you like
﻿