Position: Index > Unclassified >

PCB Etcher

2017-12-23 00:15  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

After UV-80 vas built there was a thought about automatic PCB Etcher with autonomous Heater and bubble machine. This project is hanging in prefinished phase but it does a job. It was used to etch several PCBa€?s. As this etcher supposed to be used for making PCBa€?s using photoresitive technology, the controller supposed to control both = the heater of etching tank and heater of developer. As Sensors there are used AD7416 digital temperature sensors. I decided to publish this small project as this is not clear when it will be finished. When it will be, I will update this article.

There is a little dirty drawing with dimensions:

image002.jpg

The dimensions are as follows 215x275x30 exterior. Inner volume is smaller as glass is 4mm thick. So overall volume is less than 1,2 liter. It is ideal volume to use one bag of ammonium persulphate or 250 grams of FeCl3. The glass plates are glued with aqua silicone. Sides are strengthened with aluminum profiles (not necessary if you have skills of gluing aquariums).

image004.jpg

As you can see it is only manual control:)Thermometer, heater and tank with etchant.
Thermometer has scale with more than 50?°C as solution shouldna€?t exceed this value. Heater is used from fish tank 90W:

image006.jpg

This heater heats solution up to 50 degrees in about half an hour. This is enough time to expose and develop your PCB. If you need to heat water faster a€“ you should use more powerful heater.
This is nothing to add more to this part. This is working well, but you have to stare and not to overheat the solution.
In order to make heater work automatically we decided to create controller with temperature sensor. Due to problems in assembly, this part is not finished. And there is no bubble machine purchased. Bubble machine is good to speed up etching and process is going smoother. As bubble machine we probably will use aquarium bubble pomp.
So what do we have now?
We have simple circuit on atmega8 with ability to read two temperature sensors and ability to control two relays to control two heaters.

image007.png

There also is two temperature sensors soldered to be ready to glue to tank glass. I thin it should read temperature quite well – maybe little calibration will be needed.
The sensor view:

image010.jpg

All control board will be placed in PC power block a€“ we just have one spare to use. As it has already 5V to power controller and 12V for relays and developer heater. FYI, developer heater will be heating wire from some medical equipment. It is powered from 12V and takes about 2 a€“ 3 A (36W). It is enough, as developer shouldna€?t exceed 30 degrees.

image012.jpg

And here is the total view of controller. It still looks messy and not assembled. I hope one day it will be finished

image014.jpg

To be continueda€|

Source code: Source Code


Reprinted Url Of This Article:
http://www.scienceprog.com/pcb-etcher/