Position: Index > Unclassified >

Pocket Receiver with ZN414

2018-01-22 15:26  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
Pocket Receiver with ZN414 & LM386

 

Pocket Receiver with ZN414 & LM386

 


This device is very similar to the one being described in the previous project. The most important difference is that the LF signal exiting the ZN414 does not go to the transistor amplifier but to the power amplifier built around the LM386, which was used in some previous projects. Any other audio amplifier can be used instead, e.g. those on Pics.


With this receiver, special care should be taken regarding the voltage on pin No.1. As you did in previous project, put the potentiometer?s slider in mid-position, turn the receiver on and tune it to some station. Move the slider carefully, until you reach the optimum reception. Start changing the capacitance of the variable capacitor, covering its entire scope, to make sure that receiver works well in its entire operating range. If a problem occurs, re-position the slider again. When everything gets OK, turn the receiver off, disconnect the potentiometer, measure its resistance, and solder the resistor of such resistance on the board. The R2 resistance must be no less than 600 Ohms.








Reprinted Url Of This Article:
http://electronics-diy.com/electronic_schematic.php?id=936