﻿ Rs-232C signal transmission line driven Circuits_Circuit Diagram World ﻿
Position: Index > Unclassified >

# Rs-232C signal transmission line driven Circuits

2017-08-15 08:25
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
In a signal transmission circuit, a logic circuit performs a logical calculation to at least an inputted signal to output a transmission signal. A signal line driver circuit is connected to an end of a signal line, and drives the signal line in accordance with the transmission signal. The other end of the signal line is connected to a receiver.The circuit illustrates a way to power CMOS  ICs from RS-232C lines. TheMAX680  is normally used to generate a voltage equal to ?±2 Vcc?· This circuit does exactly the opposite. It takes in?±10.5to?±12V on the DTR and TD lines and puts out a 5.25- to 6-V signal. A pair of Schottky or silicon diodes rectifies each RS-232C line. The resultant energy is stored by the capacitors attached to the IC`s V and V - pins. CI or both CI and C2 then reverse-charge pump the energy stored at the V and V- pins to C3. The input source current of the MAX680 is approximately equal to the voltage drop of any one of the diodes that is divided by the series resistance of 160 . When you drive this circuit from a 1488 driver with a ?± 12-V supply, it can deliver 5 V at 3 mA. To increase the output current, you can use as many as three sets of diodes on each RS-242 line to provide 5 V at 8 mA. The more diodes you use, the lower the source resistance: Rs equals the inversion of the sum of the diodes` conductances. If your circuit requires even more output current, you can place two MAX680s in parallel, tie their V and V- capacitors together, and use separate CI and C2 capacitors for each ship. If you do connect the devices in parallel, make sure not to exceed the power capability of the RS-232C lines.A protection line is provided in parallel to the signal line. A protection line driver circuit is connected to an end of the protection line, and drives the protection line in accordance with a protection signal having a same phase as the transmission signal.

Maybe you like
﻿