Position: Index > Unclassified >

Sample-and-hold

2017-08-17 15:41  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


The LM101A provides gain and buffers the input from storage capacitor C2. R2 adds a zero in the open loop response to compensate for the pole caused by the switch resistance and C2, improving the closed-loop stability. R1 provides a slight delay in the digital drive to pins 1 and 9. C1 provides cancellation of coupled charge, keeping the sample-and-hold offset below 5 mV over the analog signal range of -10 through 10 V.
Sample-and-hold

Aperture time is typically 1 p.s, the switcl>.ing time of the DG441. Acquisition time is 25 p.s, but this can be improved by using a faster slewing op amp. Droop rate is typically less than 5 mV/s at 25?°C.



Reprinted Url Of This Article:
http://www.next.gr/meter-counter/meters/sample-and-hold-l13687.html