Position: Index >

Synchronization by The Mains Voltage (DG413DYZ)

2017-07-22 00:54  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

 

On the circuit diagram below show us a schematic of step-down circuit which is used to approximately divide by two the rms voltage between the line input and the inductive load (L1). C2 and R3 give a turn-on delay of approximately 7 ms.

The diode bridge, with diodes D1 and D2 and R2 resistors have a function to discharge C2 at each line zero voltage. This will maintain the same turn-on delay and reset the voltage charge at each new half line cycle.

The power dissipation is reduced by the transil through R3. Here’s the circuit diagram:
Synchronization by The Mains Voltage circuit schematic diagram

Note: Transil is a transient voltage suppression (TVS) diode, an electronic component used to protect sensitive electronics from voltage spikes induced on connected wires. Transil is trademark of

This article describes the Synchronization by The Mains Voltage (DG413DYZ). The content is very simple, very helpful. Components in this article can help you understand better understanding of this article. For example, in this article, you can go to find and buy these components:DG413DYZ.

 

 


Reprinted Url Of This Article:
http://wiringdiagramcircuit.com/power-control-synchronization-by-the-mains-voltage/