Position: Index > Unclassified >

TDA7000 FM Radio Receiver Circuit

2017-12-21 23:47  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

tda7000 fm radio or receiver with lm386 amplifier


TDA7000 FM Radio Receiver Circuit Using Tuning Capacitor
GENERAL DESCRIPTION The TDA7000 is a monolithic integrated circuit for mono FM portable radios or receivers where a minimum on peripheral components is important (small dimensions and low costs).
The IC has an FLL (Frequency-Locked-Loop) system with an intermediate frequency of 70 kHz. The i.f. selectivity is obtained by active RC filters. The only function which needs alignment is the resonant circuit for the oscillator, thus selecting the reception frequency. Spurious reception is avoided by means of a mute circuit, which also eliminates too noisy input signals. Special precautions are taken to meet the radiation requirements.

The TDA7000 includes the following functions:
· R.F. input stage
· Mixer
· Local oscillator
· I.F. amplifier/limiter
· Phase demodulator
· Mute detector
· Mute switch

tda7000 fm radio receiver  circuit using Tuning Capacitor

This circuit is typical using with a? LM386 for the audio power amplifier.

With a minimum on peripheral components we can build a high performance and small FM radio receiver .

PARTS LIST
C10.22μF (224)
C222nF (223)
C310nF (103)
C427pF
C522pF
C63.3nF (332)
C7180pF (181)
C8330pF (331)
C93.3nF (332)
C10150pF (151)
C1182pF
C1268pF
C13220pF (221)
C14100nF (104)
C15330pF (331)
C16220pF (221)
C171.5nF (152)
C18470nF (474)
C19100nF (104)
VC1FM Tuning Capacitor (15-30pF)
R110kΩ
R222kΩ
R310kΩ
L15? (5.75) Turns of 23 swg enamelled copper wire close-wound on a 3mm diameter. (≈78nH)
L24? (4.75) Turns of 23 swg enamelled copper wire close-wound on a 3mm diameter. (≈70nH)
IC1TDA7000
ANTTelescopic antenna or 1m wire
S1Mute Switch (mute is disabled when switch is on.)

TDA7000 FM Receiver Coils

tda7000 fm radio Tuning coil L1tda7000 fm radio antenna coil L2
L1:Tuning Coil, 5? (5.75) Turns of 23 swg enamelled copper wire close-wound on a 3mm diameter.L2: Antenna Coil, 4? (4.75) Turns of 23 swg enamelled copper wire close-wound on a 3mm diameter.

TDA7000 IC

TDA7000 FM Radio OR FM Receiver IC

TDA7000 QUICK REFERENCE DATA
Supply voltage range (pin 5)VP2.7 to 10 V
Supply current at VP = 4.5 VIPtyp. 8 mA
R.F. input frequency rangefrf1.5 to 110 MHz
Sensitivity for -3 dB limiting
(e.m.f. voltage)
(source impedance: 75 Ω; mute disabled)
EMFtyp. 1.5 mV
Signal handling (e.m.f. voltage)
(source impedance: 75 Ω)
EMFtyp. 200 mV
A.F. output voltage at RL = 22 kΩVotyp. 75 mV

tda7000 Block diagram fm radio receiver

TDA7000 FM Radio Using Tuning Capacitor

tda7000 fm radio Receiver

Please send your ideas, which are very important for our success…

Share


Reprinted Url Of This Article:
http://www.electronicecircuits.com/electronic-circuits/tda7000-fm-radio-receiver-circuit