Position: Index > Unclassified >

Tape recorder interface

2017-09-05 21:47  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.


The interface allows data to be saved on an ordinary tape recorder at a speed of 2400 bit/s. The serial stream of data Fig. 1 (A) is coded with a clock of 2400 Hz (B), by means of XOR gate IC 1/1. Logical `high` and `low` appear as shown in Fig. 2 (C). These impulses are lowered in amplitude and feed into the record input of a low cost tape recorder. During the playback, pulses (D) are amplified with CMOS gate IC 1/2 connected as a linear amplifier, and providing a TTL level signal shown in (E). On both positive and negative transitions IC 1/4 forms short pulses as shown in (F) (approx. 50 *ts) that triggers one shot IC2. A monostable one shot pulse width is adjusted to be 3A of bit length (310 ?μ??).
Tape recorder interface

A change from `high` to `low` in a coded stream generates a `low` pulse width of one bit cell. The same is for change from ' low'' to ' 'high'' that generates a `high` pulse of the same width. During this pulse one shot latches the state of line in D type flip-flop IC3 (G). When a stream consists of multiple `ones` or `zeros,` the one shot is retriggered before it comes to the end of the quasistable state and the state of the flip-flop remains unchanged. The original data stream is available at the output of the flip-flop (). Z80 the DUART that receives these pulses is programmed so that the receiver clock is 16 times the data rate (38.4 kHz).



Reprinted Url Of This Article:
http://www.next.gr/other-circuits/game-circuits/tape-recorder-interface-l12384.html