Position: Index > Unclassified >

Voltage Follower With 1g Ohm Input Resistance electronic cir

2018-01-20 04:36  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.
Voltage follower with 1G ohm input resistance electronic circuit diagram

This circuit uses an LM11 to form a voltage follower with 1G ohm input resistance built using standard resistor values. With the input disconnected, the input offset voltage is multiplied by the same factor as R2; but the added error is small because the offset voltage of the LM11 is so low. When the input is connected to a source less than 1G ohm, this error is reduced. For an ac-coupled input a second 10M resistor could be connected in series with the inverting input to virtually eliminate bias current error; bypassing it would give minimal noise.

Source: Electronics Lab


Reprinted Url Of This Article:
http://www.free-circuits.com/circuits/miscellaneous/283/voltage-follower-with-1g-ohm-input-resistance