Position: Index > Unclassified >

What is surface mounting

2017-12-22 21:18  
Declaration:We aim to transmit more information by carrying articles . We will delete it soon, if we are involved in the problems of article content ,copyright or other problems.

Simply talking surface mounting is a soldering technology where component is soldered directly to a series of solder pads called a footprint. It is different soldering technology from through hole, where component leads are inserted into holes of the board. Footprint is a series of pads that conform to the lead layout of packages of surface mount devices (SMD).

SMD_through_hole

Surface mounting has several advantages over through hole technology. First of all the board become much smaller. So smaller boards and more dense placement of elements reduce costs. Because of higher placement density traces between components becomes shorter. It lowers parasitic inductance and capacitance.

SMD_table

Table shows the changes while redesigning the through hole board to SMT. We can see the board size were reduced by 59%, the number of layers was reduced from 6 to 4 and the costs were cut in half.

Now everyday new components are introduced. Probably there is harder to find some components in DIP packages rather than SMD. Now you can find all passive elements in SMD packaging like resistors, inductors, capacitors, ICs, switches, crystals, relays, transformers.

So if you decided to use SMD components in your design remember, that most of SMDs are designed for automated pick and place equipment so they cannot be easily manipulated by hands. First what you will be is magnifying glass, because most of SMD are extremely small. Laying out and etching SMD board is much like same as through hole board. The biggest difference is that there is no holes in PCB.

Hold breath while placing the components on the board and be sure you won’t sneeze. If so you will have hard time to find them. It is better to use some glue to stick them to the board before soldering. Use smaller tweezers to handle components then Iron them with less heat metallized ends.

After soldering is done a€“ clean remaining flux and inspect the board with magnifying glass. Have fun with SMD.


Reprinted Url Of This Article:
http://www.scienceprog.com/what-is-surface-mounting/